A request for a planetary carrier assembly can cover several different purchasing requirements. A workshop may need an assembled carrier, an individual gear shaft or additional components for a final drive overhaul. Identifying the parts and defining the supplied package should therefore happen together.
The product information references E320C and E322 excavator final drive applications and lists 7Y-1432, 7Y-0225 and 7Y-1558. Photographs show a planetary carrier, a splined gear shaft and a separate ring-shaped component. Each item should be matched to the original parts information before ordering.
The three numbers in the product title should not automatically be treated as interchangeable references for one component. Additional references include 094-0580, 094-0616, 6I-6585, 094-0611 and 6D-0692, but the supplied information does not assign every number to a specific item and quantity.
Prepare an enquiry list linking each requested number to its component name, diagram position and quantity. Distinguish individual repair parts from an assembled carrier.
Preserve hyphens and leading zeros when recording references. Check similar-looking letters and digits against the original marking, including the letter I in 6I-6585.
E320C and E322 are the machine references provided in the listing. Matching also requires the complete machine model, serial number and identification of the installed travel reducer.
If the final drive has previously been replaced, use the currently installed assembly as the basis for identification. The excavator model alone does not establish every internal gear specification.
Include the carrier’s reduction stage and position in the gearbox. The supplied information does not establish a specific stage, so the component should not be classified as first-stage or second-stage from appearance alone.
Compare carrier outside diameter, overall height, central connection, pin locations and planet gear arrangement. Record gear tooth count, face width, tooth geometry and relevant installation dimensions.
Front photographs show the general arrangement, while rear and side views help identify connection details and axial positions. Measurements from removed parts support identification, but worn dimensions should not become manufacturing or acceptance tolerances.
The pictured shaft has a splined end and a gear end. Confirm overall length, shoulder positions, mating diameters, spline count and engagement length. Check the gear end separately for tooth count and face width.
A shaft entering the central opening does not by itself establish compatibility. Connection dimensions and assembly requirements should be compared with the applicable drawing or service information.
The photographs also show a light-coloured ring. Its name, material, function and part reference should be established through the parts diagram or supply list. Colour and appearance alone do not identify it as a seal or thrust washer.
If required for the repair, state whether this item must be included. Confirm the supply status of pins, bearings, washers and fasteners at the same time.