Selecting planetary carrier assemblies for a LiuGong LG240 excavator requires a clear description of the reduction stage, gear arrangement and connection dimensions. For repair workshops and parts distributors, an enquiry for an “LG240 carrier” may leave several configuration details unresolved.
The LG240SP product information shows two carrier designs and references first- and second-stage travel reduction components. Matching each requested component to the original parts diagram, removal position and dimensional information helps define the required replacement.
LG240SP is the model designation used in this product listing, while LG240 is the stated machine application reference. Buyers should also provide the complete excavator model, machine serial number and travel reducer identification.
The listing designation should not be treated as a verified original equipment part number. If the final drive has previously been replaced, record the identification of the unit currently installed.
Original component markings, gearbox identification and photographs together provide a stronger basis for matching than the machine name alone.
The product images show one carrier with a circular plate and another with an approximately triangular plate. They are labelled “First Assembly” and “Second Assembly” in the supplied presentation.
These shapes help distinguish the pictured components during an enquiry. However, the final stage assignment should be checked against the original reducer diagram and removal position.
Do not assume that one plate shape identifies the same stage in every LG240 final drive configuration. Send front, rear and side photographs, and specify whether the requirement covers one stage or components for both stages.
Check overall diameter, assembly height, central connection arrangement, pin positions and planet gear quantity. Include the mounting faces and interfaces with adjacent components.
Photographs assist identification but do not replace dimensional records. Where the removed component is worn or damaged, use the relevant drawing or technical information to establish the replacement requirements.
Measurements from worn surfaces should not become acceptance tolerances for new parts.
Check the sun gear separately